Perancangan Kursi Pilot Helicopter Jenis Sykorski S-76 Berdasarkan Pendekatan Ergonomik
Abstract: Anthropometric
measurements of the dimensions is the study of the human body. Anthropometric
measurement difficulties caused by several factors: a) the size of the human
body is very diverse and depend on age, gender, ethnicity, so some group work
often demands certain requirements. Objective article focuses on the effort to
design chairs Helicopter pilots Sykorski type S-76 based on the concept and
principles of ergonomics.
Some of the data required for the design work is based on the principle
of the pilot seat with ergonomic support anthropometric data, among others,
namely: Data Width backrest (LS), High backrest (TS), Wide Hips (LP), High
Popliteal (TPL), popliteal Ass (PPL) which is supported by data size adult
Indonesia (Central Jakarta Usahid student anthropometric data).
After the direct measurement data processing based on uniformity test
data. Uniformity test is intended to homogenize the data in an Upper Control
Limit (UCL) and Lower Control Limit (LCL). Once all the data is uniform,
followed by testing the adequacy of the
data to determine whether the data is uniform can represent all the data
available with the provisions of N ' N.
If the test result data is uniform and meets the adequacy of the data,
performed data sorting sizes from small to
the largest percentile calculations and used P5, P50 and P95 with a
normal distribution method is to approach the average value using a 5% level of
accuracy and level of 95% confidence.
Based on the data obtained from the calculation can be done designing
Helicopter pilot seat types Sykorski S-76 that meets the principles of
ergonomics.
Penulis: Kohar Sulistyadi
Kode Jurnal: jptinformatikadd130194
