APLIKASI METODA TAGUCHI UNTUK MENGETAHUI OPTIMASI KEBULATAN PADA PROSES BUBUT CNC
ABSTRACT: In this paper
surface optimization for the surface roundness has been done by considering the
cutting parameters as cutting speed, feed rate and depth of cut. The
experiments were performed on a CNC lathe, and the materials used for the
experiment is steel St.60, with 100 mm length and 1" diameter. For design
and optimize the results experiments used Taguchi method, and to predict the
level of significance tests that contribute to the unity of the surface is done
by ANOVA with Minitab 15 software. From this research the optimized values
contributing as cutting speed 60 m/menit, feed 0.2 mm/rev and depth of cut
0,125 mm respectively. To find out the extent to which the accuracy of the
minimum values of surface roundness, then do validation on parameter values
corresponding to the optimization of the minimum value of the parameter.
Penulis: Pranowo Sidi,
Muhammad Thoriq Wahyudi
Kode Jurnal: jptmesindd130276
